MOUNT AND BLADE WIKI ENGINEER INSTALL
Install the vending module into the frame.Wrench the frame down where you want the vending machine.Select a Vending Machine Frame when using the steel sheets in your hand.Items you want to stock in the vending machine.You didn't think you could run a tax-free shop and not be a subsidiary of the station, did you? Player-made vending machines can even be edited to uniquely show some of the items in stock! Ten percent of all revenue is delivered directly to your station's Cargo Budget. You're able to make your own vending machines and sell items to other players, with the funds received going directly to the bank account attached to the registered ID card. Optionally, turn the lining on/off by clicking on it with wirecutters.Note you cannot change glow for the O-shape. You can set it so there's a glow on both ends, glow at the right end, glow at the left end, or no glow at all. Optionally, configure the pattern of the glows on the ends of the lining by clicking on it with a multitool.Optionally, change which direction the lining's facing by clicking on it with a screwdriver.There are 6 possible shapes, all of which run across the borders/sides of a tile: a line that's a tile long, a line that goes only half as far, a square/circle/O-shape, a U-shape, a tile-length L-shape, and a half-tile-length L-shape. Optionally, set the shape by clicking on it with a wrench.Available colors include yellow, blue, and pink. Optionally, before laying down lining, click on the neon lining while it's in your hand to cycle through the possible colors.if you're looking to the left side of the screen, the neon lining will be on the left side of the tile you put it on. Orientation matches the direction your character is facing, e.g.
Click on the floor tile of interest with the neon lining in your hand to lay down neon lining on that tile.Lining runs off its own internal power source that never runs out, so you can deploy it in areas that have no power. Said power can come from two sources: the local APC (capped at ~80 BURN) or a direct, wired connection to the power grid (scales with the engine's output, and can even vaporize somebody). Also, the room must have power for the chair to work. Electric chairs can be remotely activated, but must be toggled on before usage (right click, and select controls). To change the default frequency/code, you must click on the electropack while you're holding it, and modify it from the pop-up interface.
After a delay, this will give you a microwave frame that can be deployed later with a soldering iron.
3.3.3 Reinforced window (one direction).